Connect to Topcat

Connect PageFirst sensor to the Topcat.

The sensor needs to be hardwired back to the Topcat.

  1. Insert the euroblock connector of the wire into the PageFirst input jack on the Topcat. Secure with a screwdriver by tightening the screw on the left and right sides of the terminals (Figure 2).

  2. Route the wire from the Topcat to the paging speaker.

    NOTE: When routing wire make sure to secure to the building structure, as electrical and building codes require.

  3. Connect the pigtail of the sensor clip to the length of wire, using the provided wire nuts. Coil and secure excess wire as needed. NOTE: wire can be cut and stripped to the appropriate length if necessary.

 

PreviousNext